中埋式尼勒克縣管廊工程用橡膠止水帶尼勒克縣管廊工程用橡膠止水帶尼勒克縣管廊工程用橡膠止水帶
Rubber sealing water belt in Nilka County of Nilka County pipe Corridor project used in Nilka County
在這物價飛漲、價格戰變本加厲的年代，地板企業幾乎一致抱怨成本高、利潤低。不少企業行走在微利的邊緣，在人力招募、興建廠房、購買設備等環節上，稍有差池便會陷入虧損的境地。然而，令人費解的是，地板企業一面抱怨成本太高，一面又在不經意間浪費成本，這種浪費常常不容易讓人察覺，但經年累月之下，數字極為驚人。這不禁令人反思，已過而立之年的地板行業，究竟是怎么了？不想長大，戰略支撐地板企業抗風險能力太差，主要的原因在于自己不想長大，起碼，有很多地板企業只是想著發一筆橫財、賺一筆而已，這樣的企業從未想過長大。說他們不想長大，更多地是強調一種戰略支撐的制度，在這種大中，短期內看似能節約成本，但常常因決策的轉換，而造成巨大浪費。首先，短視的企業比較容易在決策時搖擺不定，因為沒有長期的戰略方向，者常常抱有不見兔子不撒鷹的心態，但消費市場天然帶有不確定性，真正等到訂單姍姍遲來之時，留給企業的時間已經非常少，這種狀態下，人員不得不走一些非常規手段。比如興建廠房，需要符合消防規范，向消防局報建，但因工期緊張，只能打擦邊球，而且品質也會因此受到比較大影響，一旦出現品質異常，工廠常常需要付出4倍的成本進行返工。
At this price, the soaring price war become aggravated era, almost the same floor enterprises complain about the high cost, low profit. Many enterprises walk on the edge of a small profit, in the recruitment, the construction of the plant, the purchase of equipment and other aspects, go astray will fall into a loss situation. However, it is puzzling, the floor side enterprises complained that the cost is too high, but also inadvertently wasted costs, this waste is often not easy to make people aware, but under the digital extraordinary month after month and year after year. This can not help but reflect on, has been the flooring industry is how the thirty years of age,? Do not want to grow up, the strategic support for flooring enterprises is too poor to resist risks. The main reason is that they don't want to grow up. At least, many floor businesses only want to make a windfall and earn a profit. At the same time, such enterprises never want to grow up. They don't want to grow up, they emphasize more on a strategy supporting system. In such a big and medium term, they seem to save costs, but often cause huge waste due to the transformation of decisions. First of all, short-sighted enterprises easier to swing in the decision, because there is no long-term strategic direction, often have could not withdraw Eagle mentality, but the consumer market with natural uncertainty, wait until the real order coming when the enterprise has very little time left, this state, people have to take some unconventional means. For example, the construction of the plant, need to comply with fire regulations, report to the fire department, but due to tight deadlines, can only play the edge ball, but the quality will be relatively large impact, once the abnormal quality, the factory often need to pay 4 times the cost of rework.
橡膠止水帶，
Rubber sealing belt,
這是一種主要用于在混凝土變形縫、伸縮縫等混凝土內部設置的止水帶產品，具有以橡膠材料彈性和結構形式來適應混凝土伸縮變形的能力。本產品是利用橡膠的高彈性和壓縮變形性，在各種荷載下產生彈性變形，從而起到緊固密封有效地防止建筑構件的漏水，滲水，并起到減震緩沖作用，可確保工程建筑物的使用壽命。
It is a kind of waterstop product which is mainly used for the construction of concrete deformation joints and expansion joints. It has the ability to adapt to the expansion and deformation of concrete with elastic material and structural form. This product uses elastic and compression deformation of rubber to produce elastic deformation under various loads, so as to create a fastening seal, effectively prevent leakage and seepage of building components, and play the role of shock absorption and buffering, so as to ensure the service life of engineering buildings.
二、用途及適應溫度橡膠止水帶主要用于混凝土現澆時必須設有的性變形縫內，如水渠、引出口、擋水壩、輸水渡槽等。中埋式橡膠止水帶適應溫度：普通型：-25℃-+60℃；耐寒型：-40*C-+60℃ 。
Two, use and adapt to the temperature, rubber sealing belt is mainly used for the concrete deformation when it is cast-in-place, such as canal, outlet, dam, aqueduct and so on. Medium buried rubber water stop belt adapts to temperature: common type: -25 C -+60 C; cold resistant type: -40*C-+60 C.
三、分類 1、中埋式橡膠止水帶產品分類從材料選擇來區分可分為中埋式橡膠止水帶、中埋式PVC止水帶、中埋式止水帶接頭和中埋式遇水止水帶等。 2、從結構形式上可分為CB型止水帶和CP型止水帶兩種。四、選用我們對于此種橡膠止水帶設計及選用： 在工程設計及施工選用中，CB型止水帶的寬度及厚度應按以下條件確定: 1、水壓小于4m,水平和垂直變形量不超過10mm 時，止水帶的寬度不宜小于200mm，厚度不宜小于5mm； 2、水壓為4-8m，水平和垂直變形量不超過30mm時，CB型止水帶的寬度不宜小于300mm，厚度不宜小于6mm； 3、水壓大于8m,水平和垂直變形量超過30mm時，CB型止水帶的寬度不宜小于350mm ,厚度不宜小于8mm； 4、水壓不大于8m,水平變形量不超過20mm，當無垂直變形時，CB型止水帶的寬度不宜小于200mm,厚度不宜小于5mm。除此之外，當結構斷面尺寸大于500mm時，CB型止水帶的寬度不宜小于300mm，當CB型止水帶進行彎曲放置時，其轉彎半徑不得小于300mm。中埋式橡膠止水帶產品按止水帶GBl8173.2—2000是利用橡膠的高彈性和壓縮變形性，在各種荷載下產生彈性變形，從而經濟型中埋式橡膠止水帶起到緊固密封有效地防止建筑構件的漏水，滲水，并起到減震緩沖作用，可確保工程建筑物的使用壽命。本產品主要用于混凝土現澆時必須設有的性變形縫內，如水渠、引出口、擋水壩、輸水渡槽等。中埋式鋼邊止水帶
Three, classification 1, embedded rubber water stop products classification can be divided into buried rubber water stop, buried PVC water stop, buried water stop joint and buried underwater water stop belt and so on. 2. It can be divided into two kinds of CB type water stop belt and CP type water stop belt from the structure form. Four, we selected the design and selection for the rubber seal: in the selection of engineering design and construction, the width and thickness of CB type waterstop shall be determined in accordance with the following conditions: 1, the water pressure is less than 4m, the horizontal and vertical deformation is not more than 10mm, the sealing belt width of not less than 200mm, the thickness of not less than 5mm; 2, the water pressure is 4-8M, the horizontal and vertical deformation is not more than 30mm, CB type strip width should not be less than 300mm, the thickness of not less than 6mm; 3, the water pressure is greater than 8m, the horizontal and vertical deformation of more than 30mm, CB strip width not less than 350mm, the thickness of not less than 4, 8mm; the water pressure is greater than 8m, the level of deformation is not more than 20mm, when no vertical deformation, CB strip width of not less than 200mm, the thickness of not less than 5mm. Besides, when the structural section size is larger than 500mm, the width of the CB type water stop should not be less than 300mm. When the CB type water stop belt is bent, the turning radius should not be less than 300mm. In the embedded rubber water stop belt waterstop products by GBl8173.2 - 2000 is the use of rubber elasticity and high compression deformation, elastic deformation under various loads, and economical in embedded rubber water stop belt sealing to effectively prevent the fastening of building components Water Leakage, seepage, and play a cushioning, can ensure the the service life of the building project. This product is mainly used in the deformation joints which must be set in the concrete pouring, such as water channel, outlet, dam, water transfer aqueduct, etc. Middle buried steel edge water stop belt
