鄂爾多斯止水鋼板400*3多少錢一米
鋼板止水帶用途：
Application of steel sealing strip:
在箱型基礎或地下室，底板和外墻板的混凝土是分開澆搗的，下次再澆搗墻板混凝土時，就有一條施工縫，當這條縫的位置在地下水位線以下時，就容易產生滲水。這樣就需要對這條縫進行技術處理。 處理的方法很多，其中比較通行的方法是設置鋼邊止水帶。
In the box foundation or basement floor and wall panels are separated from the concrete pouring, pouring concrete wall again, there is a construction joint, when the crack position below the underground water level, it is easy to produce water. This requires a technical treatment of the seam. There are many ways to deal with it. The most popular way is to set up steel stop pipe.
即在澆筑下層混凝土時，預埋300*3的鋼板，其中有10-15cm的上部露在外面，在下次再澆筑混凝土時把這部分的鋼板一起澆筑進去，起到阻止外面的壓力水滲入的作用。鋼板止水帶選擇的厚度一般為2mm厚 3mm厚。一般鋼板止水帶是采用冷軋板作為母材，因為冷板厚度能夠均勻，熱板一般厚度達不到均勻的程度，厚度一般為2毫米或者3毫米，長度一般加工成3米長或者6米長，一般為三米好運輸。鋼邊止水帶對焊接節點要求較高，不能出現漏點，影響防水性能。
鄂爾多斯止水鋼板400*3多少錢一米
In the lower concrete pouring, pre buried steel plate of 300*3, including the upper portion of the 10-15cm exposed, this part of the steel pouring in together again during the pouring of concrete, to prevent the outside pressure of water infiltration effect. The thickness of the steel sealing strip is usually 2mm thick and 3mm thick. General plate sealing strip is made of cold rolled plate as a base material for cold plate thickness can be generally uniform, hot plate thickness is not up to the uniform degree of thickness is 2 mm or 3 mm in length, generally processed into 3 meters long or 6 meters long, three meters generally good transportation. The steel edge sealing strip requires higher welding nodes, and no leakage point can be found, which affects the waterproof performance.
施工要點：
Construction points:
1、應盡力保證鋼邊止水帶在墻體中線上；
1, should try to ensure that the steel side of the water retaining wall in the middle of the wall;
2、兩塊鋼板之間的焊接要飽滿確保不滲水，一般是雙面焊。根據監理要求，也可以單面焊接；
2, two pieces of steel between the welding should be full, to ensure that no water seepage, generally double-sided welding. According to the supervision requirements, can also be single-sided welding;
3、墻體轉角處的處理，一、整塊鋼板彎折；二、丁字型焊接；三、7字型焊接。
3, the wall corner processing, one, the whole plate bending; two, T-shaped welding; three, 7 type welding.
4、鋼邊止水帶的支撐焊接，可以用小鋼筋電焊在主筋上；
4. The supporting welding of the steel stop belt can be welded with small steel bars on the main reinforcement;
鄂爾多斯止水鋼板400*3多少錢一米
5、鋼邊止水帶穿過柱箍筋時，可以將所穿過的箍筋斷開，制作成開口箍，電焊在鋼板上。
5. When the steel stop belt passes through the column hoop, the hoop hoop which is worn can be broken off and made into an opening hoop, and the electric welding is arranged on the steel plate.
鋼板止水帶即在澆筑下層混凝土時，預埋300mmx3mm的鋼板，其中有10-15cm的上部露在外面，在下次再澆筑混凝土時把這部分的鋼板一起澆筑進去，起到阻止外面的壓力水滲入的作用。一般鋼板止水帶是采用冷軋板作為母材，因為冷板厚度能夠均勻，熱板一般厚度達不到均勻的程度，厚度一般為2毫米或者3毫米，長度一般加工成3米長或者6米長，一般為三米好運輸。止水鋼板對焊接節點要求較高，
In the plate strip pouring bottom concrete, pre buried steel plate of 300mmx3mm, including the upper portion of the 10-15cm exposed, this part of the steel pouring in together again during the pouring of concrete, to prevent the outside pressure of water infiltration effect. General plate sealing strip is made of cold rolled plate as a base material for cold plate thickness can be generally uniform, hot plate thickness is not up to the uniform degree of thickness is 2 mm or 3 mm in length, generally processed into 3 meters long or 6 meters long, three meters generally good transportation. The water stopping steel plate requires higher welding nodes,
止水鋼板焊接節點
Welded joint of water stopping steel plate
止水鋼板焊接節點
Welded joint of water stopping steel plate
不能出現漏點，影響防水性能。
Leakage can not occur, affecting waterproof performance.
施工要點
Construction points
1、應盡力保證止水鋼板在墻體中線上；
1, should try to ensure that the steel plate in the wall of the center line;
2、兩塊鋼板之間的焊接要飽滿且為雙面焊 ，鋼板搭接不小于20mm；
The welding between the 2 and two steel plates should be full and double sided welding, and the steel plate shall be lapped not less than 20mm;
3、墻體轉角處的處理，一、整塊鋼板彎折；二、丁字型焊接；三、7字型焊接。
3, the wall corner processing, one, the whole plate bending; two, T-shaped welding; three, 7 type welding.
4、止水鋼板的支撐焊接，可以用小鋼筋電焊在主筋上；
4 、 the support welding of water stopping steel plate can be welded with small steel bars on the main reinforcement;
5、止水鋼板穿過柱箍筋時，可以將所穿過的箍筋斷開，制作成開口箍，電焊在鋼板上。
5. When the water stopping steel plate passes through the column hoop, the hoop hoop which is crossed can be broken and made into an opening hoop, and the electric welding is arranged on the steel plate.
6、止水鋼板的“開口”朝迎水面。
6. The opening of the water stop steel plate faces the water surface.
鄂爾多斯止水鋼板400*3多少錢一米
